Configures an OSPF area as a stub area.
| area-identifier | Specifies an OSPF area. |
| summary | Specifies that type-3 can be propagated into the area. |
| nosummary | Specifies that type-3 cannot be propagated into the area. |
| cost | Specifies a cost metric. |
N/A.
A stub area is connected to only one other area. The area that connects to a stub area can be the backbone area. External route information is not distributed into stub areas. Stub areas are used to reduce memory and computation requirements on OSPF routers.
The following command configures an OSPF area as a stub area:
configure ospf area 0.0.0.6 stub nosummary stub-default-cost 10
This command was first available in ExtremeXOS 10.1.
This command is available on platforms with Base license, or higher, as described in the Switch Engine v33.1.1 Licensing Guide document.